Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual - Manual (Page 27)

Rockwell Automation Publication 1756-UM001O-EN-P - October 2014 27
Install the 1756-L7x Controller Chapter 1
1. Verify that the SD card is not in use by checking to be sure that the
SD indicator is Off.
2. Open the door to access the SD card.
3. Press and release the SD card to eject it.
IMPORTANT • Verify that the SD card status indicator is off and that the card is not in use
before removing it.
• We recommend that you do the following:
–Leave an SD card installed.
– Use the SD cards available from Rockwell Automation (catalog number
1784-SD1 or 1784-SD2).
• While other SD cards can be used with the controller, Rockwell Automation
has not tested the use of those cards with the controller. If you use an SD
card other than those cards that are available from Rockwell Automation,
you can experience data corruption or loss.
• Also, SD cards that are not provided by Rockwell Automation do not have
the same industrial, environmental, and certification ratings as those cards
that are available from Rockwell Automation.
TIP You can also put the controller into Hard Run mode to keep the
controller from writing to the SD card while it is removed.
Logix 55xx
RUN FORCESD OK