Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual - Manual (Page 47)

Rockwell Automation Publication 1756-UM001O-EN-P - October 2014 47
Start Using the Controller Chapter 3
Figure 3 - USB Connection
Configure the USB Driver
To configure RSLinx software to use a USB port, you must first configure a USB
driver.
To configure a USB driver, perform this procedure.
1. Connect your controller and workstation by using a USB cable.
The Found New Hardware Wizard dialog box appears.
2. Click any of the Windows Update connection options and click Next.
TIP If the software for the USB driver is not found and the installation is
canceled, verify that you have installed RSLinx Classic software,
version 2.57 or later.
Logix 55xx
RUN FORCESD OK
32007-M