Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual - Manual (Page 174)

174 Rockwell Automation Publication 1756-UM001O-EN-P - October 2014
Chapter 11 Using the PhaseManager Tool
PhaseManager Tool versus
Other State Models Table 44 compares PhaseManager state models to other state models.
Equipment Phase
Instructions The controller supports several equipment-phase relay ladder and structured text
instructions.
For more information about instructions for use with equipment phases, see the
PhaseManager User Manual, publication
LOGIX-UM001 .
Table 44 - PhaseManager Tool and Other State Models
PhaseManager Tool S88 PackML
Resetting…Idle Idle Starting…Ready
Running…Complete Running…Complete Producing
Subroutines or breakpoints Pausing…Paused Standby
Holding…Held Holding…Held Holding…Held
Restarting Restarting None
Stopping…Stopped Stopping…Stopped Stopping…Stopped
Aborting…Aborted Aborting…Aborted Aborting…Aborted
Table 45 - Instructions for Use with PhaseManager Tool
Instruction Instruction Function
PSC Signal a phase that the state routine is complete and to go ahead to the next state.
PCMD Change the state or substate of a phase.
PFL Signal a failure for a phase.
PCLF Clear the failure code of a phase.
PXRQ Initiate communication with RSBizWare™ Batch software.
PRNP Clear the NewInputParameters bit of a phase.
PPD Configure breakpoints within the logic of a phase.
PATT Take ownership of a phase to one of the following:
• Stop another program or RSBizWare Batch software from commanding a phase.
• Make sure another program or RSBizWare Batch software does not own a phase.
PDET Relinquish ownership of a phase.
POVR Override a command.