Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual - Manual (Page 65)

Rockwell Automation Publication 1756-UM001O-EN-P - October 2014 65
Start Using the Controller Chapter 3
Figure 6 - Operation Mode
Load or Store to the
Memory Card The memory card that is compatible with your ControlLogix controller is used to
load or store the contents of user memory for the controller.
Store to the Memory Card
After you are online with the controller and have changed the controller to
Program or Remote Program mode, complete these steps to store a project to the
memory card.
1. Open the Controller Properties dialog box and click the
Nonvolatile Memory tab.
2. Click Load/Store.
TIP For this example, the controller mode switch is set to Remote mode. If your
controller mode switch is set to Run or Program modes, the menu options
change.