Dell C5765DN MFP Color Laser Printer - Manual (Page 308)

15 Tools
308
When you enter the amount in [Number of Sheets] and press [Sample Printout], the
machine prints the sample that the values changed are reflected.
Delete All Certificates/Initialize Settings
Deletes all certificates stored in the machine and initializes the security settings associated
with certificates. This feature is designed to use when you cannot use a certificate data in the
machine because of an abnormality of certificate file even when the certificate is set to
enabled for [SSL/TLS Settings] under [Connectivity & Network Setup] > [Security
Settings].
Notify Job Completion by E-mail
You can receive the results of jobs performed by an e-mail notification.
Targeted Jobs
Select the service whose job result you want to receive by an e-mail notification. When the
target job is already selected, [Selected] is displayed.
You can select more than one target job from [Copy], [Fax], [Scan], [Print], or [Report].
Select the notification timing from [Notify at the End of Job] or [Notify when Error Only].
E-mail Addresses 1 to 5
Specify the e-mail addresses to notify the result of the jobs.
Note • When you select [Save] to exit this screen without specifying an e-mail address, the setting of
[Targeted Jobs] or [E-mail Message] is deleted.
E-mail Message
Enter a comment attached to the e-mail.
Plug-in Settings
When you use custom services, you can set whether to enable embedded plug-ins and display
the list of the plug-ins.
Embedded Plug-ins
Set whether to enable embedded plug-ins.
List of Embedded Plug-ins
Displays [Name] and [Status] of embedded plug-ins.
Other Settings
You can configure other settings related to the machine.
Offset Stacking (Left Tray)
Offsetting means that each set of copies is delivered to the left tray and shifted slightly
toseparate it from the previous job. When a set of copies is delivered to the front of the tray,
the next set is delivered to the rear of the tray. Set the offset function for the Left Tray. Select
from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per Set] or [Offset
per Job] is selected, the machine slightly shifts the output position per set or per job (print
job) respectively.