Dell C5765DN MFP Color Laser Printer - Manual (Page 556)

22 Problem Solving
556
003-702 [Cause] You tried to copy sides 1 and 2 of a document simultaneously specifying different
Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-750 [Cause] Unable to store any documents using the 2 Sided Book Copying feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "Layout Adjustment" (P.83).
003-751 [Cause] Unable to process the document because the specified scan area is too small.
[Remedy] Increase the resolution or scan area.
003-752 [Cause] A mix sized document was to be scanned at 600 dpi in Color/2 sided.
[Remedy] Set [Resolution] to [400 dpi] or lower, and try scanning again.
003-753 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [200 dpi], and scan the document again.
003-754
003-755
[Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-756 [Cause] The faxed document is completely blank.
[Remedy] Check whether the document is blank or whether the side of the document to be faxed
is loaded correctly.
003-757 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [300 dpi] or lower, and scan the document again.
003-760 [Cause] An incompatible combination of feature is specified for document scan conditions.
[Remedy] Confirm the selected options.
003-761 [Cause] The paper size of the tray selected for auto tray differs from the paper size of the tray
selected for Auto Paper selection.
[Remedy] Change the paper size for the tray, or change the [Paper Type Priority] settings.
003-763 [Cause] An error occurred when reading the Calibration Chart.
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.248).
003-780 [Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce / Enlarge] to decrease the data size, or
split the data to send it separately.
003-795 [Cause] When enlarging/reducing a scanned document to the paper size specified, the
reduction/enlargement ratio exceeds the allowed range.
[Remedy] Take one of the following measures:
• Manually enter a reduction/enlargement ratio.
• Change the paper size.
005-210 [Cause] An error occurred in the document feeder.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact Customer Support at
dell.com/contactdell.
005-275
005-280
[Cause] An error occurred in the document feeder.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact Customer Support at
dell.com/contactdell.
Status Code Cause and Remedy