Dell C5765DN MFP Color Laser Printer - Manual (Page 339)

Connectivity & Network Setup
339
Note • To encrypt communications using this feature, a trusted root certificate authority and all intermediate
certificate authorities that are registered in the path of a certificate to use must be registered.
Attribute Type of Certificate
Set the certificate attribute type. Select and enter the field name to use as a certificate from
among the user information registered on the LDAP server. Up to 32 single-byte characters
are allowed.
For Windows, enter "userCertificate;binary" for an attribute name used as certificate
information. The information is used as an S/MIME certificate when you specify an address
using the directory service to encrypt e-mail transmission by S/MIME.
Note • To encrypt communications using this feature, a trusted root certificate authority and all intermediate
certificate authorities that are registered in the path of a certificate to use must be registered.
Maximum Number of Search Results
Set a maximum number of address to display from search results from 5 to 100. If the search
results exceed the maximum, the search stops at the maximum number set. The default
value is 50.
Search Time-Out
Select whether or not to set a search time-out. Set the value from 5 to 120 seconds in 1
second increments.
Directory Service for Address Book
Select whether or not to use an address book stored on the directory server.
Even when [Enabled] is selected, the address book for the directory server will not be started
unless the following conditions are satisfied.
• The IP address of the machine must be set.
• The IP address or Internet address of the directory server (primary) must be set.
• The port numbers used for LDAP communication must be set on the directory server and
the machine.
SMB Server Settings
SMB Server Setup
Select the server specification method from [By Domain Name] and [By Domain & Server
Names/IP Address].
According to the option you selected here, set [Domain Name] and [Server Name/IP
Address] for SMB servers 1 to 5 respectively. The setting for SMB server 1 is used as the
default setting for authentication.
Domain Name
Enter the domain name of the server. Up to 64 characters are allowed.
This setting is mandatory regardless of the SMB server specification method selected for
[SMB Server Setup].
Note • Use the NetBIOS or Active Directory domain name for the domain name.
Server Name/IP Address
Enter the server name or IP address.
This setting is valid when [SMB Server Setup] is set to [By Domain & Server Names/IP
Address].
Note • Use the NetBIOS computer name or full computer name with DNS suffix for the server name.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.