Dell C5765DN MFP Color Laser Printer - Manual (Page 347)

Print Service Settings
347
Specify a value for the dedicated IPP receiving buffer memory capacity from 64 to 1024 KB
in 32 KB increments.
Spool to Hard Disk
Carries out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer.
Specify a value from 1024 to 2048 KB in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port 9100 receiving buffer.
Specify a value from 64 to 1024 KB in 32 KB increments.
Delete Form
You can delete registered ESC/P-K forms.
1
Select [Delete Form].
2
Select the print mode to delete forms.
ESC/P
Deletes ESC/P-K emulation forms.
Form Number
When you select an item to delete, you can enter
the form number.
Form Name
After you enter the form number and select [Confirm], the form name matching the form
number entered appears.
3
Enter the form number with the numeric keypad, and select [Confirm].
4
Check the form name, and then select [Delete Data].
Other Settings
You can configure other settings related to the paper used in the printer.
Print Area
Set whether or not to expand the print area.
Substitute Tray
When there is no tray containing the paper size selected by the Auto Paper selection, select
whether or not to print with paper loaded in another paper tray. In the event of using a
substitute tray, select the paper size from [Use Larger Size], [Use Closest Size], or [Select
Tray 5].
Note • When documents are printed using emulation such as ESC/P-K and HP-GL/2, the substitute tray
setting is not valid and a message prompting you to load paper displayed on the screen.