Dell C5765DN MFP Color Laser Printer - Manual (Page 441)

Installation When Using EtherTalk
441
Installation When Using EtherTalk
This section describes how to install the machine using EtherTalk.
The following shows the reference section for each procedure.
Step 1 Preparations.................................................................................................................. 441
Step 2 Configuration on the Machine ................................................................................... 441
Step 3 Configuration on the Computer................................................................................. 442
Dell Printer Configuration Web Tool Setting Items ............................................................ 442
Step 1 Preparations
The following items are required to set up the machine to use the EtherTalk interface.
• EtherTalk network environment
Step 2 Configuration on the Machine
The following describes the configuration procedures to use EtherTalk on the machine.
Note • You can configure the settings using Dell Printer Configuration Web Tool. For the items that can be
configured using Dell Printer Configuration Web Tool, refer to "Dell Printer Configuration Web Tool
Setting Items" (P.442).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's passcode,
and select [Enter].
Note • The default user ID is "admin".
• The default passcode is "1111".
3) Select [Tools] on the [Home] screen.
2
Enable the EtherTalk port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [EtherTalk], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Select [Close] repeatedly until the [Tools] screen is displayed.
4
Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
5
Print a configuration report to confirm that the EtherTalk port is enabled.
For information on how to print a configuration report, refer to "Print Reports" (P.260).
6
Configure other EtherTalk settings as necessary.
For information on the EtherTalk settings, refer to "Dell Printer Configuration Web Tool Setting
Items" (P.442).