Dell POWEREDGE M1000E - Manual (Page 24)

xxiv Fabric OS Command Reference
53-1001764-02
• fcipPathTest - Revised, updated examples.
• turboRamtest - Revised, updated examples.
• portLedTest - Updated examples.
• portLoopBackTest - - Updated examples.
Dynamic area mode on default switch
• configure - New option to enable or disable Dynamic Area Mode.
• portAddress - Port Address binding is now supported on the default switch as well after you
enable Dynamic Area Mode with the configure command.
• wwnAddress - Dynamic Area Mode and WWN-Based persistent PID must be enabled on the
switch before you can assign an address with this command.
Encryption
• New command options to support replication for remote host access to data. Supported only
with RSA RKM key vault.
• CryptoCfg --add - Enhanced to support replication (new -newLUN parameter).
• CryptoCfg --decommission - New command group to support device decommissioning.
• CryptoCfg --manual_rekey - Modified to support replication (-include_mirror with the -all
option).
• CryptoCfg --rebalance - Support for combined disk and tape containers on a single
Encryption Engine including load balancing for optimized throughput.
• CryptoCfg --refreshDEK - Rereads the mirror LUN metadata and updates the FPGA tables for
the LUN.
• CryptoCfg --set -replication - Configures replication mode.
• CryptoCfg --show -container - Enhanced display includes new parameters, "New LUN" and
"Replication LUN type".
• CryptoCfg --show -groupcfg/-egstatus - Enhanced display “Replication Mode” status and
includes diagnostic output to detect incorrectly configured connectivity settings.
• CryptoCfg --show -localEE - Enhanced display to show rebalance status.
• CryptoCfg --sync -securitydb - Synchronizes security database across encryption group to
rectify master key propagation failure.
Fabric Watch
The interactive Fabric Watch configuration interface (fwConfigure) has been replaced with a
command-driven set of new Fabric Watch commands. All Fabric Watch configuration and displays
can now be performed non-interactively. The legacy commands will be removed in a subsequent
release.
• poprtFencing - port and area updates.
• portThConfig - Support for VE_Ports and Copper ports added.
• sysMonitor - Support for configuring Environment and Resources classes.
• thConfig (see new commands) - Configures FW thresholds for the SFP, Fabric, Security, Filter,
and End-to-End Performance Monitor classes.