Portcfgdefault – Dell POWEREDGE M1000E User Manual

Page 674

Advertising

642

Fabric OS Command Reference

53-1001764-02

portCfgDefault

Resets the port configuration to factory default values.

Synopsis

portcfgdefault [slot/][ge]port

Description

Use this command to reset all configuration values on a specified port to their factory defaults. This
command persistently disables ports capable of routing, which is the factory default value. Use the
portCfgShow command to display the port configuration.

This command does not change the state of a port. To change the state of an E_Port, use either
switchDisable/switchEnable or portDisable/portEnable.

When issued on a Brocade 8000 in Access Gateway mode, this command resets the buffer limited
mode on all N_Ports. It also returns the maximum NPIV per port login limit to the default value of
126 on all ports, including FCoE ports.

Note

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.

Operands

This command has the following operands:

slot

For bladed systems only, specifies the slot number of the port to be reset,
followed by a slash (/).

port

Specifies the number of the port to be reset, relative to its slot for bladed
systems. Use switchShow to list of valid ports.

Examples

To reset a port to factory defaults:

switch:admin>

portcfgdefault 1/3

To reset a GbE port to factory defaults:

switch:admin>

portcfgdefault 8/ge1

To reset a an FCoE port on a Brocade 8000 in Access Gateway mode:

switch:admin>

portcfgdefault 13

switch:admin>

portcfgshow

Area Number: 13

Speed Level: AUTO(HW)

Fill Word: 0(Idle-Idle)

Trunk Port ON

Locked N_Port OFF

Persistent Disable OFF

LOS TOV enable OFF

NPIV capability ON

QOS Port AE

Port Auto Disable: OFF

Rate Limit OFF

F_Port Buffers OFF

NPIV PP Limit: 126