Dell POWEREDGE M1000E - Manual (Page 527)

Fabric OS Command Reference 495
53-1001764-02
lsanZoneShow
2
lsanZoneShow
Displays logical SAN zone information.
Synopsis lsanzoneshow [-s] [-f fabricid] [-w wwn] [-z zonename]
Description Use this command to display the inter-fabric zones or LSAN zones. These zones are normal WWN
zones created in FC Router EX_Port-connected fabrics and backbone fabrics. The LSAN zones are
identified by the text string “lsan_” in the zone name. Note that the string is case insensitive so
“LSAN_” also is valid. The FC Router uses these zones to establish the inter-fabric device import
and export policy. The LSAN zones are established by zoning administration in each
EX_Port-attached fabric and backbone fabric. Inter-fabric device sharing is allowed between two
devices if the LSAN zones defined in their respective fabrics both allow the two devices to
communicate; for example, the intersection of LSAN zones in two fabrics define the device sharing
policy.
The LSAN zones are listed by fabric. Zone membership information (information about the devices
in the zone) is provided for each LSAN zone. The default output displays only WWNs of the zone
members.
Search parameters -f, -w, and -z allow searching for LSAN zones based on fabric ID, WWN of an
LSAN zone member, or LSAN zone name.
"No LSAN zone found" is displayed if there is no LSAN zone information available at this FC Router.
Each LSAN zone entry displays the following:
Fabric ID The ID of the fabric in which the LSAN zone was created.
Zone Name The zone name.
Zone Members The zone members or devices. The default output displays the WWN of the
zone members.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-s Displays state information for the device. Valid states include:
Configured Device is configured to be in an LSAN, but the device is neither imported nor
exists in this fabric.
Initializing Device is in an intermediate state. It is not yet imported into the fabric.
EXIST Device exists in this fabric (the fabric of the zone entry).
Imported Device has been imported (proxy created) into this fabric.
-f fabricid Displays LSAN zones in the specified fabric.
-w wwn Displays LSAN zones containing the specified port WWN. The WWN format is
xx:xx:xx:xx:xx:xx:xx:xx.
-z zonename Displays LSAN zones with the specified zone name. The database for zones is
displayed per switch, which can differ from the database stored on the other
FCR switches.