Dell POWEREDGE M1000E - Manual (Page 306)

274 Fabric OS Command Reference
53-1001764-02
fcpProbeShow
2
fcpProbeShow
Displays the Fibre Channel Protocol (FCP) probe information.
Synopsis fcpprobeshow [slot/]port
Description Use this command to display the Fibre Channel Protocol daemon (FCPD) device probing
information for the devices attached to the specified F_Port or FL_Port. This information includes
the number of successful logins and SCSI INQUIRY commands sent over this port and a list of the
attached devices.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
slot For bladed systems only, specify the slot number of the port to display,
followed by a slash (/).
port Specify the port number to display, relative to its slot for bladed systems. Use
switchShow to list valid ports. This operand is required.
Examples To display the FCP probe information:
switch:admin>
fcpprobeshow 4/4
port 52 is L-Port and it is online.
nodes probed: 2
successful PLOGIs: 2
successful PRLIs: 2
successful INQUIRies: 2
successful LOGOs: 2
outstanding IUs: 0
probing state: 3
probing TOV: 0
probing count: 0
probing next: 0
pmap: 0x00000000, 0x00000000, 0x00000000, 0x00000010
update map: 0x00000000, 0x00000000, 0x00000000, 0x00000010
list of devices(may include old devices on the loop):
0x2b4e2: IBM DDYF-T09170R F60N
0x2b4e4: IBM DDYF-T09170R F60N
See Also portLoginShow, portLogShow