Dell POWEREDGE M1000E - Manual (Page 776)

744 Fabric OS Command Reference
53-1001764-02
portShow
2
portShow
Displays status and configuration parameters for ports and GbE ports.
Synopsis portshow [slot/][ge]port
portshow -i [index1[-index2] [...]] [-f]
portshow option [slot/]ge_port [optional_args]
portshow option [ all |ve_port] arguments [optional_arguments]
portshow option [ all |ge_port] arguments [optional_arguments]
Description Use this command to display general port status and specific configuration parameters for a
specified port, GbE port, or VE_Port.
If this command is executed for a specified port with no additional options, it displays general
status and configuration for that port. If executed with optional arguments for a Gigabit Ethernet
(GbE) port or VE_Port, the command displays FCIP-related port configuration parameters specific to
the Brocade 7800/FX8-24 and the Brocade 7500/7500E/FR-18i platforms.
This command has been modified to support the display of FCIP tunnels on the Brocade 7800 and
FX8-24 platforms. As a result, the behavior of this command in Fabric OS v6.3.0 and later has
changed.
You must use this command in a manner that honors the platform-specific differences in
command syntax and behavior. Some command options are not available on all platforms. Others
behave differently depending on the platform on which they are executed.
Platform-specific commands are documented in separate sections that include function, synopsis,
description, operands, and examples. Use the following section headings to navigate this page.
• “General port status display commands supported on all platforms”
• “Port display commands supported only on the Brocade 7800/FX8-24 and on the Brocade
7500/7500E/FR4-18i platforms”
- portshow ipif - Displays the local IP interfaces.
- portshow arp - Displays the content of the address resolution protocol (ARP) table.
- portshow iproute - Displays static routes on the IP interface.
- portshow vlantag - Displays the IP interface VLAN configuration.
• “Commands supported only on the Brocade 7800 and the Brocade FX8-24”
- portshow fciptunnel - Displays Fibre Channel over IP (FCIP) tunnels.
- portshow fcipcircuit - Displays FCIP circuits.
• “Commands supported only on the Brocade 7500/7500E and FR4-18i”
- portshow fciptunnel - Displays Fibre Channel over IP (FCIP) tunnels.
- portshow iscsi - Displays ISCSI configuration.
- portshow mode - Displays GbE port mode.
- portcfg ficon - Displays FICON emulation parameters.
- portshow inbandmgmt - Displays IP addresses and routes for the CP or GbE port inband
management interfaces (Brocade 7500/7500E only).
To display command usage on the switch, use portShow [action].