Dell POWEREDGE M1000E User Manual
Page 627
Fabric OS Command Reference
595
53-1001764-02
perfTTmon
2
Operands
This command has the following operands:
slot
For bladed systems only, specifies the slot number of the port on which to
install Top Talkers, followed by a slash (/).
port
Specifies the number of the port on which the Top Talker is to be installed,
relative to its slot for bladed systems. Use switchShow for a list of valid ports.
F_Port Top Talker commands:
--
add
Installs the Top Talker monitor on a specified F_Port.
egress | ingress
Used with the --add option to specify the direction in which the traffic is
monitored as incoming or outgoing. This operand is required.
--
show
Displays the top talking flows on a specified port.
number of top talking flows
Specifies "n" top talking flows. Valid values are between 1 and 32. If a value
greater than 32 is entered, Top Talker displays counters for only 32 flows and
a warning message. This operand is optional; if omitted, the command
displays the top 8 flows.
wwn | pid
Specifies the output display as either WWN or PID format. This operand is
optional. If omitted, the command displays in WWN format.
--
delete
Deletes an existing Top Talker monitor on a specified F_Port.
Fabric Mode Top Talker commands:
--
add fabricmode
Installs the Top Talker monitor on all switches in the fabric. When a new
switch joins the fabric, this command must be run again on the switch. The TT
configuration information is not propagated automatically to the new switch.
--
show
Displays the Top Talking flows on the switch for a given domain ID.
dom dom_id
Specifies the domain ID for the flow display.
number of top talking flows
Specifies "n" Top Talking flows. Valid values are between 1 and 32. If a value
greater than 32 is entered, Top Talker displays counters for only 32 flows and
a warning message. This operand is optional; if omitted, the command
displays the top 8 flows.
wwn | pid
Specifies display as either WWN or PID format. This operand is optional; if
omitted, the command displays in WWN format.
--
delete fabricmode
Deletes the Fabric Mode Top Talker.
Examples
To add an F_Port Top Talker to blade 1 port 2 (which should be an F_Port):
Switch:admin>
perfttmon --add ingress 1/2
To delete the F_Port Top Talker:
switch:admin>
perfttmon --del 1/2