Fcrconfigure – Dell POWEREDGE M1000E User Manual

Page 312

Advertising

280

Fabric OS Command Reference

53-1001764-02

fcrConfigure

Sets FC Router configuration parameters.

Synopsis

fcrconfigure

Description

Use this command to configure the FC Router parameters for this platform. This is an interactive
command.

This command cannot execute on a system with the FC Router feature enabled. First disable FC
routing by using fosConfig or disable the switch with switchDisable.

Note

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.

Operands

This command interactively prompts for the following parameter:

Backbone Fabric ID A fabric ID uniquely identifies a fabric in FC Router configurations. The

backbone fabric is the fabric attached to the U_Ports—for example,
E/F_Ports—of this switch. The backbone fabric ID must be unique across all
FC Router-connected fabrics. The current Backbone Fabric ID can be
displayed using the switchShow command.

Examples

To configure FC Router parameters:

fcr:admin>

fcrconfigure

FC Router parameter set. <cr> to skip a parameter

Please make sure new Backbone Fabric ID does not conflict with any configured

EX-Port's Fabric ID

Backbone fabric ID: (1-128)[128]