Frureplace – Dell POWEREDGE M1000E User Manual

Page 389

Advertising

Fabric OS Command Reference

357

53-1001764-02

fruReplace

Provides an interactive interface to help replace a field replaceable unit (FRU).

Synopsis

frureplace fru

Description

Use this command to replace a FRU. The command automatically performs the necessary backup
and restore operations to accommodate the replacement.

Note

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.

Operands

The following operand is required:

fru

Specify the type of hardware component being replaced. WWN is the only
supported value, specifying the replacement of the WWN card.

Examples

To replace the world wide name card:

switch:admin>

frureplace wwn

This is the WWN card hot swap interface.

Continuing from this point will require

the whole process to be completed.

If this process is not complete due to a

power cycle, or CP failover, please follow

the recovery procedure in

Core Switch WWN Card Removal and

Replacement document.

Do you wish to continue [y/n]?

Backing up WWN card data, please

wait about 25 seconds for further

instruction.

Please install the new FRU now.

If this session lost for any reason,

please re-enter the frureplace command and

follow the instructions to complete the

operation.

Please enter the word `continue' after the

new WWN card has been installed:

continue

Restoring the information to the

replacement FRU now, please wait about

20 seconds to complete

Verifying the replacement FRU now...

WWN card hot swap is now complete.

FRU replacement completed successfully!