Dell POWEREDGE M1000E User Manual
Page 327
Fabric OS Command Reference
295
53-1001764-02
fcrPathTest
2
DIAG-STATS
The ASIC internal error counters detected an error in the received frame. This
error is similar to ERRSTATS, but includes verifying the Tx/Rx frame count
statistics. The DIAG-STATS error can be caused by a faulty SFP or indicate
deeper problems in the main board or ASIC. Check for a faulty SFP. Replace
the cable or SFP if necessary.
DIAG-TIMEOUT
The port failed to receive back a frame that was sent out. This can be caused
by a faulty SFP or indicate deeper problems in the main board or ASIC. Check
for a faulty SFP. Replace the SFP if necessary.
DIAG-XMIT
The specified port failed to transmit frames. This usually indicates an ASIC
failure. Replace the blade or the switch.
See Also
fcrChipTest, portLoopbackTest