Dell POWEREDGE M1000E - Manual (Page 949)

Fabric OS Command Reference 917
53-1001764-02
supportShowCfgEnable
2
supportShowCfgEnable
Enables a group of commands to be displayed under the supportShow command.
Synopsis supportshowcfgenable os | exception | port | fabric | services | security | network | portlog |
system | extend | filter | perfmon | ficon | iswitch | asic_db |ag | dce_hsl |crypto | fcip
Description Use this command to enable a group of commands to be displayed under the supportShow
command. Use the supportShowCfgDisable command to disable groups of commands.
The FCIP commands are supported only on the Brocade 7800/FX8-24 and 7500/7500E/FR4-18i
platforms and cannot be configured to collect data on unsupported platforms.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
os Enables the OS group commands.
exception Enables the exception group commands.
port Enables the port group commands.
fabric Enables the fabric group commands.
services Enables the service group commands.
security Enables the security group commands.
network Enables the network group commands.
portlog Enables the portlog group commands.
system Enables the system group commands.
extend Enables the extend group commands.
filter Enables the filter group commands.
perfmon Enables the Performance Monitor group commands.
ficon Enables the FICON group commands.
iswitch Enables the FC Router group commands.
asic_db Enables the ASIC DB group commands.
iscsi Enables the iSCSI group commands.
ag Enables the Access Gateway group commands.
dce_hsl Disables the DCE group commands
crypto Enables the encryption group commands.
fcip Enables the FCIP group commands. Supported only on the Brocade
7800/FX8-24 and 500/7500E/FR4-18i.