Dell POWEREDGE M1000E - Manual (Page 964)

932 Fabric OS Command Reference
53-1001764-02
switchShow
2
(downstream) The E_Port is a downstream path away from the principal switch of the fabric.
Persistently Disabled
This port has been disabled with the portCfgPersistentDisable command.
FICON Persistent DID
This port has been disabled, because the switch could not obtain its
configuration domain ID during the fabric reconfiguration when fmsmode was
enabled. See the ficonCupSet help page for more information.
Fabric ID conflict
Two different fabrics have been assigned the same fabric ID. Applicable only
to EX_Ports and Logical Fabric environments.
Fabric ID oversubscribed
One fabric has been assigned two different fabric IDs (EX_Ports only).
AoQ Application-oriented QoS; indicates that an F_Port or N_Port has negotiated a
link that is capable of quality of service (QoS). Both sides of the link have QoS
capability and agreed on the protocol. The link could be between an HBA and
an Access Gateway, between an Access Gateway and an edge switch, or
between an HBA and an edge switch.
If the Access Gateway cannot negotiate QoS capabilities with the edge switch,
an HBA connected to the Access Gateway will not be able to negotiate a QoS
link with the Access Gateway.
A Server Application Optimization (SAO) license is required to enable QoS at
the HBA. An Adaptive Networking license is required both at the Access
Gateway and the edge switch to enable QoS.
(logical) Indicates a logical port. The switchShow output shows all logical ports
currently present in the logical switch. The command displays -1 for the slot
for logical ports and the user port number for slot port. The logical port
numbers are not persistent and may change when the logical interswitch
links (LISLs) are deleted and recreated. A logical port is shown to be in one of
the following states: E_Port (if the port is online), offline, or disabled. When
the port is disabled, a reason is provided.
When used with the -slot option, the command displays the following blade-specific information:
slot Slot number.
Blade Type Type of blade, for example, Core blade or AP blade. Refer to the slotShow
command for a listing of supported blade types.
ID A numeric blade ID that specifies the blade type. Refer to the slotShow
command for a listing of supported blade IDs.
Status Enabled or disabled.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.