Dell POWEREDGE M1000E - Manual (Page 287)

Fabric OS Command Reference 255
53-1001764-02
FCoE
2
FCoE
Manages and displays FCoE configuration.
Synopsis fcoe --cfgshow [[slot]port]
fcoe --disable [slot]port
fcoe --enable [slot]port
fcoe --loginshow [[slot]port]
fcoe --fcmapset -vlan vid fcmapid
fcoe --fcmapunset -vlan vid
fcoe --fipcfg -advintvl intvl
fcoe --fipcfgshow
fcoe --resetlogin [-teport slot/port | -device wwn ]
fcoe --help
Description Use this command to configure and display the status of FCoE ports, FCoE Initialization Protocol
(FIP), and FCMAP settings.
Unlike regular FC ports, FCoE ports are embedded interfaces that are not directly associated with
an external physical port on the switch. Although show commands such as switchShow display
FCoE ports as “ports,” configuration of these ports through the regular FC CLI is disabled. Only the
FCoE CLI commands can be used.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands.
slot Specifies the slot number on bladed systems, followed by a slash (/).
port Specifies the port number. There are 24 configurable embedded FCoE ports
on the Brocade 8000 switch, and the valid range for port is 8 to 31. On the
Brocade FCoE 10-24 blade, there are 24 configurable FCoE ports numbered
0-23. Use switchShow for a list of valid FCoE ports.
--
help Displays the command usage.
--
cfgshow Displays the configuration of a specified embedded FCoE port. If a port is not
specified, the command displays all port configurations.
--
disable Disables the specified FCoE port.
--
enable Enables the specified FCoE port.
--
loginshow Displays information about the devices logged into the specified FCoE port.
--
fcmapset Configures the FCMAP values for Fabric Provided MAC Addresses (FPMA) for
the specified VLANs.
-vlan vid Specifies the VLAN for which to set the FCMAP.
fcmapid Specifies the FCMAP to be set.