ADLINK PCI-8154 - Manual (Page 114)

104 MotionCreatorPro
position1<-->position2). It is only effective when “Rela-
tive Mode” or “Absolute Mode” is selected.
11. Vel. Profile: Select the velocity profile. Both Trapezoidal
and S-Curve are available for “Absolute Mode,” “Relative
Mode,” and “Cont. Move.”
12.FA Speed/ATU: Sets the configurations of the FA
Speed. The related function calls are
_8154_set_fa_speed(). If the check box “ATU” is
checked, it will execute auto homing when motion starts.
13.Motion Parameters: Set the parameters for single axis
motion. This parameter is meaningless if “Manual Pulser
Move” is selected, since the velocity and moving dis-
tance is decided by pulse input.
Z Start Velocity: Set the start velocity of motion in units of
PPS. In “Absolute Mode” or “Relative Mode,” only the
value is effective. For example, -100.0 is the same as
100.0. In “Cont. Move,” both the value and sign are
effective. –100.0 means 100.0 in the minus direction.
Z Maximum Velocity: Set the maximum velocity of motion
in units of PPS. In “Absolute Mode” or “Relative Mode,”
only the value is effective. For example, -5000.0 is the
same as 5000.0. In “Cont. Move,” both the value and