ADLINK PCI-8154 - Manual (Page 222)

212 Function Library
6.23 Return Code
The return error code is defined in “8154_err.h”. The meaning is
described in following table.
Code Meaning
0 No error
-10000 Error Card number
-10001 Error operation system version
-10002 Error card’s ID conflict
-10300 Error other process exist
-10301 Error card not found
-10302 Error Open driver failed
-10303 Error ID mapping failed
-10304 Error trigger channel
-10305 Error trigger type
-10306 Error event already enabled
-10307 Error event not enable yet
-10308 Error on board FIFO full
-10309 Error unknown command type
-10310 Error unknown chip type
-10311 Error card not initial
-10312 Error position out of range
-10313 Error motion busy
-10314 Error speed error
-10315 Error slow down point
-10316 Error axis range error
-10317 Error compare parameter error
-10318 Error compare method
-10319 Error axis already stop
-10320 Error axis INT wait failed
-10321 Error user code write failed
-10322 Error array size exceed
-10323 Error factor number
-10324 Error enable range