ADLINK PCI-8154 - Manual (Page 126)

116 MotionCreatorPro
14.Mode:
Z Linear Interpolation: After setting motion parameters
correctly in “Motion Parameters Setting Frame”, you can
enter the destination in this frame. Then click Run button
to start linear interpolation motion.
Z Circular Interpolation: The setting for circular interpola-
tion mode has three additional parameters in “Motion
Parameters Setting Frame”. They are arc degree, divi-
sion axis and optimize option. Please refer to section 6.7
and 6.8 to set them.
After setting these parameters, you can enter the arc center
and degree in “Play Key Frame”. Click Run button to start cir-
cular interpolation motion.
Jog Type: Continuous Jog
Continuous Jog means that when you press one directional
button, the axis will continuously move with an increasing
speed. The longer you press, the faster it runs. When you un-
press the button, the axis will stop immediately.
Incremental Jog: Incremental jog means that when you click
one directional button, the axis will step a distance according to
the Step-Size’s setting.