ADLINK PCI-8154 - Manual (Page 190)

180 Function Library
clr_mode : Specify a CLR input clear mode
clr_mode = 0 , Clear on the falling edge (default)
clr_mode = 1 , Clear on the rising edge
clr_mode = 2 , Clear on a LOW level
clr_mode = 3 , Clear on a HIGH level
targetCounterInBit : Enable/Disable clear target counter in bit
inp_enable : INP function enabled/disabled
inp_enable = 0, Disabled (default)
inp_enable = 1, Enabled
inp_logic : Set the active logic for the INP signal
alm_logic : Setting of active logic for ALARM signals
alm_mode : Reacting modes when receiving an ALARM signal.
Value Meaning
Bit Description
0 Reset command counter when CLR input turns ON
1 Reset position counter when CLR input turns ON
2 Reset error counter when CLR input turns ON
3 Reset general purpose counter when CLR input turns ON
Value Meaning
0 Negative logic
1 Positive logic
Value Meaning
0 Negative logic
1 Positive logic
Value Meaning
0 motor immediately stops (default)
1 motor decelerates then stops