ADLINK PCI-8154 - Manual (Page 31)

Signal Connections 21
can select the output mode either by jumper wiring between 1 and
2 or 2 and 3 of jumpers JP2-JP9 as follows:
The default setting of OUT and DIR is set to differential line driver
mode.
The following wiring diagram is for OUT and DIR signals of axis.
PCI-8154:
NOTE: If the pulse output is set to open collector output mode,
OUT- and DIR- are used to transmit OUT and DIR signals. The
sink current must not exceed 20mA on the OUT- and DIR- pins.
The default setting is 1-2 shorted.
Output Signal
For differential line driver
output, close breaks
between 1 and 2 of:
For open collector out-
put, close breaks
between 2 and 3 of:
OUT0+ JP6 JP6
DIR0+ JP7 JP7
OUT1+ JP4 JP4
DIR1+ JP5 JP5
OUT2+ JP9 JP9
DIR2+ JP8 JP8
OUT3+ JP3 JP3
DIR3+ JP2 JP2