ADLINK PCI-8154 - Manual (Page 25)

Installation 15
2.6 K1/K2 Pin Assignments: Simultaneous Start/
Stop
K1 and K2 are for simultaneous start/stop signals for multiple axes
or multiple cards.
Note: +5V and GND pins are provided by the PCI Bus power.
2.7 JP2 to JP9 Jumper Setting for Pulse Output
JP2-JP9 are used to set the type of pulse output signals (DIR and
OUT). The output signal type can either be differential line driver
or open collector output. Refer to section 3.1 for detail jumper set-
tings. The default setting is differential line driver mode. The map-
ping table is as follows:
No. Name Function
1 +5V PCI Bus power Output (VCC)
2 STA Simultaneous start signal input/output
3 STP Simultaneous stop signal input/output
4 GND PCI Bus power ground
Table 2-2: K1/K2 Pin Assignments: Simultaneous Start/Stop
JP6 & JP7 Axis 0
JP4 & JP5 Axis 1
JP8 & JP9 Axis 2
JP2 & JP3 Axis 3