Doremi DC-POST - Manual (Page 84)

19 Using the RCV2 for Variable Speed Playback
Please see the attached document “RCV2 Controller” for installation procedures and general
information.
JOG/SHUTTLE WHEEL FUNCTIONS: Activates the following function when lit:
JOG: In Jog mode, the rotation of the Internal wheel will generate "Jog" steps in forward or reverse.
SHUTTLE: In Shuttle mode, the angle of the external wheel from its initial position will control the
shuttle speed with 7 different values in each direction: 10%, 20%, 48%, 100%, 200%, 500%, 1000% in
>> or <<. The value used and the direction (">>", "<<") is displayed on the bottom line of the LCD
during the shuttle operation.
SLO MO: Activates the external wheel for slow motion control. The slow motion is forward only with
predefined values of 0%, 3%, 10%, 15%, 20%, 26%, 30%, 39%, 48%, 60%, 65%, 75%, 81%, 87%,
93%, 100%.
STOP: Stop control button. The STOP key will cause the DC-Post to stop any transport control (Play,
record, rewind, fast forward).
PLAY: Play control button. If the active drive has recorded material, pressing the PLAY key will start
playback from the current location at normal speed and the green LED will go ON.
REW: Rewind control button with a speed of 20 times normal. When the rewind is close to the
beginning of the recording, the speed is slowed down to normal until it reaches the start. Pressing this
key again will increase the speed. There are three levels REW+REW+REW (i.e., -20, -40, -80)
FF: Fast forward control button with a speed of 20 times normal. When the fast forward is close to the
end of the recording, the speed is slowed down to normal until it reaches the end. Pressing this key
again will increase the speed. There are three levels FF+FF+FF (i.e., 20, 40, 80).
DPT.OM.001128.DRM Page 84 of 101 Version 1.2
Doremi Labs