Televes Serie H-60 User Manual
Page 158
158
General
=>
To remove the battery altogether, it should be disconnected from the connector within
the meter.
Follow the cables from the battery to locate the connector. Press the flap to free the
connector.
=>
Place the new battery in the same position as the old one and plug the connector back
in its socket.
=>
Screw the rear cover back into position.
=>
Update the battery change in the equipment software
.
Do not omit to dispose of the battery in the containers provided for
the purpose.
Make sure that there is no risk of a short circuit in the cables
leading from the battery since the high level of the current from it
could cause serious damage to the equipment.
WARNING
Precautions to be taken when replacing battery:
• Both when removing the battery from the equipment and when
reconnecting it, make sure that the meter is turned off.
• If the battery is removed from the equipment, when it is replaced,
make sure that it is properly reconnected.
• If metal tools are used for battery installation, the battery must be
insulated, because a short circuit might occur.
• Do not connect the positive and negative poles of a battery with
any metal item, since it could heat up, emit hydrogen gas,
overflow, burn or explode.
• Only batteries supplied by Televés and adapted to your
equipment may be used.
01031052_002_EN:103130_00.qxd 10/07/2013 8:01 Página 158