BECKHOFF EL7037 - Manual (Page 205)

Error correction
Interpretation
Structure of the Text ID
The structure of the MessageID is not subject to any standardisation and can be supplier-specifically
defined. In the case of Beckhoff EtherCAT devices (EL, EP) it usually reads according to xyzz:
x y zz
0: Systeminfo
1: Info
4: Warning
8: Error
1: General
2: Communication
3: Encoder
4: Drive
5: Inputs Error number
Example: Message 0x4413 --> Drive Warning Number 0x13
General Text IDs
Specific Text IDs should be specified in the device documentation.
Text ID Type Place Text (English
only) Cause
0x0001 Informatio
n System No error No error
0x0002 Informatio
n System Communication
established Communication established
0x0003 Informatio
n System Initialisation: 0x%X,
0x%X, 0x%X General information; parameters depend on
event. See device documentation for
interpretation.
0x1000 Informatio
n System Information: 0x%X,
0x%X, 0x%X General information; parameters depend on
event. See device documentation for
interpretation.
0x1100 Informatio
n General Detection of the mode of operation ended
0x1135 Informatio
n General Cycle time OK
0x1201 Informatio
n Communicatio
n Communication re-
established Communication to the field side restored
This message appears, for example, if the
voltage was removed from the power
contacts and re-applied during operation
0x1300 Informatio
n Encoder Position set - StartInputhandler
0x1400 Informatio
n Drive Drive is calibrated
0x4000 Warning Warning: 0x%X, 0x
%X, 0x%X General warning; parameters depend on
event. See device documentation for
interpretation.
0x4101 Warning General Terminal-
Overtemperature Overtemperature. The internal temperature
of the terminal exceeds the parameterised
warning threshold
0x4300 Warning Encoder Sub-increments deactivated (despite
activated configuration)
0x4301 Warning Encoder Encoder-Warning General encoder error
0x4400 Warning Drive Drive is not calibrated
0x4401 Warning Drive Start type is not supported
0x4402 Warning Drive Command rejected
0x4405 Warning Drive Modulo sub-type invalid
EL70x7 205 Version 1.0