BECKHOFF EL7037 - Manual (Page 207)

Error correction
Text ID Type Place Text (English
only) Cause
0x82FF Error Communicatio
n Boot mode not activated
0x8300 Error Encoder Error while setting the position
0x8301 Error Encoder Encoder increments not configured
0x8302 Error Encoder Feedback-Error The amplitude of the resolver is too small
0x8400 Error Drive Drive incorrectly configured
0x8401 Error Drive Limitation of the calibration velocity
0x8402 Error Drive Emergency stop activated
0x8403 Error Drive ADC Error Error during current measurement in the
ADC
0x8404 Error Drive Overcurrent Overcurrent in phase U, V or W
0x8405 Error Drive Modulo position invalid
0x8406 Error Drive DC-Link
undervoltage
(Error) The DC link voltage of the terminal is lower
than the parameterised minimum voltage.
Activation of the output stage is prevented
0x8407 Error Drive DC-Link
overvoltage (Error) The DC link voltage of the terminal is higher
than the parameterised maximum voltage.
Activation of the output stage is prevented
0x8408 Error Drive I2T-Model Amplifier
overload (Error) - The amplifier is being operated outside the
specification
- The I2T-model of the amplifier is
incorrectly parameterised
0x8409 Error Drive I2T-Model motor
overload (Error) - The motor is being operated outside the
parameterised rated values
- The I2T-model of the motor is incorrectly
parameterised
0x8415 Error Drive Modulo factor invalid
EL70x7 207 Version 1.0