Yaskawa P7B Drive Bypass - Manual (Page 177)

Programming 5 - 83
An error may occur while saving the parameter values to the digital operator’s memory. If an error is displayed, press any key
to cancel the error display and return to parameter o3-01. To COPY parameter values into a Drive, set o3-01= “2: OP->INV
WRITE”. During the writing of the parameter values into the Drive the digital operator will display:
A successful COPY of the parameter values will display:
An error may occur while writing the parameter values to the Drive. If an error is displayed, press any key to cancel the error
display and return to parameter o3-01.
It is possible to compare the parameter values stored in the digital operator with the parameter values currently in the Drive by
using the VERIFY function. This VERIFY function should not be confused with the “-VERIFY-“ that is displayed on the
digital operator when viewing the “Modified Constants” menu. To VERIFY the parameter values in the Drive as compared
with those stored in the digital operator, set o3-01= “3: OP<-->INV VERIFY”. During the comparing of the parameter values
into the Drive the digital operator will display:
A successful VERIFY of the parameter values will display:
-ADV-
COPY
OP → INV COPYING
-ADV-
COPY
COPY COMPLETE
-ADV-
VERIFY
DATA VERIFYING
-ADV-
VERIFY
VERIFY COMPLETE