Yaskawa P7B Drive Bypass - Manual (Page 19)

Physical Installation 1 - 7
Confirmations upon Delivery
!
Receiving Checks
Check the following items as soon as the Drive and Bypass unit is delivered.
If you find any irregularities in the above items, contact the shipping company, the distributor or representative you purchased
the Bypass unit from or your Yaskawa office immediately.
The Bypass unit is thoroughly tested at the factory. Any damages or shortages evident when the equipment is received must be
reported immediately to the commercial carrier that transported the material. Shipping damage is not covered by the Yaskawa
warranty. After unpacking and inspecting for damage, verify that internal wire connections have not come loose during
shipment by spot checking wire terminations with a screwdriver or the appropriate tool.
Bypass unit storage must be in a clean and dry location. Maintain the factory packaging and provide covering as needed to pro-
tect the Bypass unit from construction site dirt, water, debris and traffic prior to and during construction.
!
Bypass Nameplate Information
A nameplate is attached to the right side of the enclosure and the inside of the door of each Bypass unit.
The nameplate shown below is an example for a standard Bypass unit.
Fig 1.1 Bypass Nameplate
(Example)
Table 1.5 Checks
Item Method
Has the correct model of Bypass unit been
delivered? Check the model number on the nameplate on the right side of the Bypass unit.
Reconcile with packing slip and/or order information.
Is the Bypass unit damaged in any way?
Inspect the entire exterior of the Bypass unit to see if there are any dents,
scratches or other damage resulting from shipping.
Are any screws or other components loose? Use a screwdriver or the appropriate tool to check for tightness.
A.C. INPUT
A.C. OUTPUT
Volts: 480 Hz: 50/60
Phase: 3 Amps: 71.6
Volts: 0-480 Hz: 0-60
Phase: 3 Amps: 65
Serial No: 4W033727440-0002
Model No: P7BVB065R
Type: P7 BYPASS
W.D.: P7B-00
Inst. Manual: TM.P7B.01,CD.AFD7.01
UNPN0001