Emerson Process Management MICRO MOTION 2400S - Manual (Page 11)

Configuration and Use Manual 3
Before You Begin
St
a
rt
u
p
Usin
g P
ro
L
in
k II
T
ransmitter User
Interface
Be
fo
re
Y
o
u
Begin
In this manual:
• Basic information on using the transmitter’s user interface is provided in Chapter 3.
• Basic information on using ProLink II or Pocket ProLink, and connecting ProLink II or
Pocket ProLink to your transmitter, is provided in Chapter 4. For more information, see the
ProLink II or Pocket ProLink manual, available on the Micro Motion web site
(www.micromotion.com).
• Basic information on using a customer-supplied DeviceNet tool is provided in Chapter 5. For
more information, see the documentation provided with the tool.
1.7 Planning the configuration
Refer to the configuration overview flowchart in Figure 1-1 to plan transmitter configuration. In
general, perform configuration steps in the order shown here.
Note: Depending on your installation and application, some configuration tasks may be optional.
Note: This manual provides information on topics that are not included in the configuration overview
flowchart, e.g.: using the transmitter, troubleshooting, and calibration procedures. Be sure to review
these topics as required.