Emerson Process Management MICRO MOTION 2400S - Manual (Page 162)

154 Micro Motion ® Model 2400S Transmitters for DeviceNet ™
Device Profile
32 9-wire cable
RTD resistance REAL Get V The resistance of the
9-wire cable Unit = ohms
33 Meter RTD
resistance REAL Get V The resistance of the
meter RTD Unit = ohms
34 Number of
power cycles UINT Get V The number of transmitter
power cycles
35 Power on time Unsigned 32 Get
Reset
(1)
V The cumlative amount of
time the tranmitter has
been on since the last
reset (Class 0x01,
Attribute 0x05) Seconds since last
reset
36 Line RTD REAL Get V The resistance of the
process line RTD Unit = ohms
37 Actual target
amplitude REAL Get V The amplitude the
transmitter is attempting
to drive the sensor Unit = mV/HZ
38 Input voltage REAL Get V The number of volts on
the power input terminals Unit = volts
39 Drive current REAL Get V The drive current Unit = milliamps
40 Alarm 7 UINT Get V A collection of status bits • 0x0001 = K1/FCF
Combination
Unrecognized
• 0x0002 = Warming
Up
• 0x0004 = Low Power
• 0x0008 = Tube not
Full
• 0x0010 = Meter Ver
Fault
• 0x0020 = Meter Ver
Info
• 0x0040 =UI PROM
error
• 0x0080 = Not Used
• 0x0100 = Not Used
0x0200 = Not Used
• 0x0400 = Not Used
• 0x0800 = Not Used
• 0x1000 = Not Used
• 0x2000 = Not Used
• 0x4000 = Not Used
• 0x8000 = Not Used
Table C-7 Diagnostics Object (0x66) – Instance 1 continued
Attrib
ID
Name Data type Service Mem Description Comments