Emerson Process Management MICRO MOTION 2400S - Manual (Page 36)

28 Micro Motion ® Model 2400S Transmitters for DeviceNet ™
Required Transmitter Configuration
6.3 Configuring the measurement units
For each process variable, the transmitter must be configured to use the measurement unit appropriate
to your application.
To configure measurement units for process variables, see the menu flowcharts in Figure 6-3. For
details on measurement units for each process variable, see Sections 6.3.1 through 6.3.4.
The measurement units used for totalizers and inventories are assigned automatically, based on the
measurement unit configured for the corresponding process variable. For example, if
kg/hr (kilograms
per hour) is configured for mass flow, the unit used for the mass flow totalizer and mass flow
inventory is
kg (kilograms). DeviceNet codes used for the measurement units are listed in Tables C-12
through C-14.
Note: Pressure unit configuration is required only if you are using pressure compensation (see
Section 9.2) or you are using the Gas Wizard and you need to change the pressure units (see
Section 8.2).