Emerson Process Management MICRO MOTION 2400S - Manual (Page 177)

Configuration and Use Manual 169
D
e
vice Pr
ofile
In
de
x
Displa
y Codes
Men
u
s
Appendix D
Display Codes and Abbreviations
D.1 Overview
This appendix provides information on the codes and abbreviations used on the transmitter display.
Note: Information in this appendix applies only to transmitters that have a display.
D.2 Codes and abbreviations
Table D-1 lists and defines the codes and abbreviations that are used for display variables (see
Section 8.9.5 for information on configuring display variables).
Table D-2 lists and defines the codes and abbreviations that are used in the off-line menu.
Note: These tables do not list terms that are spelled out completely, or codes that are used to identify
measurement units. For the codes that are used to identify measurement units, see Section 6.3.
Table D-1 Display codes used for display variables
Code or abbreviation Definition Comment or reference
AVE_D Average density
AVE_T Average temperature
BRD T Board temperature
CONC Concentration
DGAIN Drive gain
EXT P External pressure
EXT T External temperature
GSV F Gas standard volume flow
GSV I Gas standard volume flow
inventory
LPO_A Left pickoff amplitude
LVOLI Volume inventory
LZERO Live zero flow
MASSI Mass inventory
MTR T Case temperature
NET M Net mass flow rate Enhanced density application only
NET V Net volume flow rate Enhanced density application only
NETMI Net mass inventory Enhanced density application only
NETVI Net volume inventory Enhanced density application only
PWRIN Input voltage Refers to power input to the core processor