Mocomtech CDM-570 - Manual (Page 17)

Page 15 of 54 MN/CDM570L.AA4 13
3.4.1 IP Commands
3.4.1.1 Admin Commands
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
System
Working Mode SWM= 1 byte, value
of 0 through 1 Command or Query here:
1 -- Router - Small Network
2 -- Router - Large Network
3 -- Router - Point to Point
4 -- Router - Vipersat
5 -- Easy Connect.
Router-Vipersat mode needs the vipersat option to be available on
the modem. Changing the address/working mode may reboot the
modem. SWM=
SWM!
SWM? SWM =x
(see description of
arguments)
EasyConnect
Multicast
Option EMO= 1 byte, value
of 0 or 1 Command or Query where,
0=Disabled
1= Enabled
Enables or disabled forwarding of multicast traffic while in
EasyConnect mode.
Valid only when in EasyConnect mode on 570. EMO =
EMO!
EMO? EMO =x
(see description of
arguments)
Header
Compression
Refresh rate –
UDP/RTP1 HRR= 3 bytes Command or Query.
Header compression refresh rate, 1 to 600
Resolution=1 packet
Refresh rate for UDP/RTP1 streams.
Example: HRR=50
Restrictions: 570 only HRR =
HRR!
HRR? HRR =xxx
(see description of
arguments)