Mocomtech CDM-570 - Manual (Page 26)

Page 14 of 54 MN/CDM570L.AA4
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
IP Address of
Ethernet
interface IPA= 15 bytes
length. Command or Query.
Used to set the IP address and mask of the Ethernet interface, in the
format:
xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP addresss
Example: 010.006.030.001
Note: To make the IPA= command effective, one needs to issue the
IPM command immediately following IPA command. IPM should
be issued even if there is no change in the subnet mask.
Changing the IP address will cause the telnet/socket connection to
break. So, the telnet/application should reconnect to the new IP
address after timeout.
For Reading also, IPA? is followed by IPM?
IPA =
IPA!
IPA? IPA= xxx.xxx.xxx.xxx
(see description of
arguments)
IP Address
Mask of
Ethernet
Interface IPM= Value of
8 – 32
Command or Query.
Sets the IP Subnet mask for the interface IP address.
yy is the submet mask in bits [8..32]
See the NOTE above for IPA.
IPM=
IPM! IPM? IPM=yy
HDLC
Address HAD 4 bytes,
Numerical
Command or Query.
Sets the one of four hdlc addresss, where:
In small network mode value is 0x01-0xFE
In large network value is 0x0001-0x7FFE
To delete, set the value to 0xFFFF.
Example:
<1/HAD[3]=AB will set the HDLC address to 0xAB
<1/HAD[2]=FFFF will Clear/Delete the HDLC Address.
In Point-to-Point or vipersat mode the values are not used. HAD=
HAD! HAD? HAD= xxxx
(see description of
arguments)