Mocomtech CDM-570 - Manual (Page 129)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Front Panel Operation MN/CDM570L.IOM
6–5
6.2 OPENING SCREEN
This screen is displayed whenever power is first applied to the unit. If the Internal
Reference warm-up delay feature has been disabled (see under UTIL, REF, Warm-up
Delay) on of the following screens is displayed (depending on modem type):
If, however, the Internal Reference warm-up delay feature has been enabled, one of the
following screens will be displayed:
The bottom right of the display counts down, in seconds, until the warm-up period is
complete. During this period, the Tx Carrier is deliberately muted. At the end of the
warm-up period, the bottom line will revert to the ‘normal’ display of Firmware version,
and the unit will enter its normal operational state. At this stage, pressing any key will
take the user to the top level selection screen.
IMPORTANT NOTE: If the user wishes to bypass this feature, the warm-up period may
be over-ridden at any time by pressing the CLEAR key.
6.3 MAIN SELECT MENU
CDM-570L CDM-570
Move the cursor to the desired choice using the ◄ ► arrow keys, then press ENTER.
Monitor
This menu branch permits the user to monitor the alarm status of
the unit, to view the log of stored events, and to display the Receive
Parameters screen.
Test
This menu branch permits the user to invoke one of several test
modes (loopbacks, for example).
Info
(Information) This menu branch permits the user to view
information on the unit, without having to go into configuration
screens.
Save/Load
This menu branch permits the user to save and to retrieve up to 10
different modem configurations.
Util
(Utility) This menu branch permits the user to perform
miscellaneous functions, such as setting the Real-time clock,
adjusting the display brightness, etc.
Comtech CDM-570L Modem
Ref Warming-up: 045 secs
IMPORTANT
Comtech CDM-570L Modem
Firmware Version:1.3.1 Comtech CDM-570 Modem
Firmware Version:1.3.1
Comtech CDM-570 Modem
Ref Warming-up: 045 secs
SELECT: Config Monitor
Test Info Save/Load Util SELECT: Config Test Info
Monitor Save/Ld Util ODU