LSI 53C875A User Manual
Page 204
5-4
SCSI SCRIPTS Instruction Set
•
The LSI53C875A typically fetches two Dwords (64 bits) and decodes
the high order byte of the first longword as a SCRIPTS instruction. If
the instruction is a Block Move, the lower three bytes of the first
longword are stored and interpreted as the number of bytes to be
moved. The second longword is stored and interpreted as the 32-bit
beginning address in main memory to which the move is directed.
•
For a SCSI send operation, the LSI53C875A waits until there is
enough space in the DMA FIFO to transfer a programmable size
block of data. For a SCSI receive operation, it waits until enough data
is collected in the DMA FIFO for transfer to memory. At this point,
the LSI53C875A requests use of the PCI bus again to transfer the
data.
•
When the LSI53C875A is granted the PCI bus, it executes (as a bus
master) a burst transfer (programmable size) of data, decrement the
internally stored remaining byte count, increment the address
pointer, and then release the PCI bus. The LSI53C875A stays off the
PCI bus until the FIFO can again hold (for a write) or has collected
(for a read) enough data to repeat the process.
The process repeats until the internally stored byte count has reached
zero. The LSI53C875A releases the PCI bus and then performs another
SCRIPTS instruction fetch cycle, using the incremented stored address
maintained in the
register. Execution of
SCRIPTS instructions continues until an error condition occurs or an
interrupt SCRIPTS instruction is received. At this point, the LSI53C875A
interrupts the host CPU and waits for further servicing by the host
system. It can execute independent Block Move instructions specifying
new byte counts and starting locations in main memory. In this manner,
the LSI53C875A performs scatter/gather operations on data without
requiring help from the host program, generating a host interrupt, or
requiring an external DMA controller to be programmed. An overview of
this process is presented in
.