LSI 53C875A - Manual (Page 80)

3-4 Signal Descriptions
3.3 PCI Bus Interface Signals
The PCI Bus Interface Signals section contains tables describing the
signals for the following signal groups:
System Signals , Address and
Data Signals , Interface Control Signals , Arbitration Signals , Error
Reporting Signals , and Interrupt Signal .
3.3.1 System Signals
Table 3.2 describes the System signals.
Table 3.2 System Signals
Name PQFP BGA Type Strength Description
CLK 145 A6 I N/A Clock provides timing for all transactions on the PCI bus
and is an input to every PCI device. All other PCI signals
are sampled on the rising edge of CLK, and other timing
parameters are defined with respect to this edge. Clock
can optionally serve as the SCSI core clock, but this may
effect fast SCSI-2 (or faster) transfer rates.
RST/ 144 B6 I N/A Reset forces the PCI sequencer of each device to a
known state. All T/S and S/T/S signals are forced to a high
impedance state, and all internal logic is reset. The RST/
input is synchronized internally to the rising edge of CLK.
The CLK input must be active while RST/ is active to
properly reset the device.