Teledyne GFC-7001T - Trace CO Analyzer - Manual (Page 112)

SetupTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 112
To access and navigate the VARS menu, use the following button sequence.
SETUP X.X 4) CLOCK_ADJUST=0 Sec/Day
PREV NEXT JUMP EDIT ENTR EXIT
SETUP X.X CLOCK_ADJUST=0 Sec/Day
+ 0 0 ENTR EXIT
Enter sign and number of
seconds per day the clock
gains (-) or loses(+).
SETUP X.X DYN_SPAN=OFF
OFF ENTR EXIT
SETUP X.X DYN_ZERO=OFF
OFF ENTR EXIT
Toggle this button to turn
the Dynamic Zero
calibration feature ON/
OFF.
Concentration display
continuously cycles
through all gasses.
SAMPLE RANGE=500.0 PPM CO= XXXX
<TST TST> CAL SETUP
SETUP X.X 0) DAS_HOLD_OFF=15.0 Minutes
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X ENTER PASSWORD:818
8 1 8 ENTR EXIT
Toggle these
buttons to enter
the correct
PASSWORD.
In all cases:
EXIT discards the new
setting.
ENTR accepts the
new setting.
SETUP X.X 2) DYN_ZERO=OFF
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X 3) DYN_SPAN=OFF
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X DAS_HOLD_OFF=15.0 Minutes
1 5 .0 ENTR EXIT
Toggle these buttons to set
the iDAS HOLDOFF time
period in minutes
(MAX = 20 minutes).
Toggle this button to turn
the Dynamic Span
calibration feature ON/
OFF.
SETUP X.X 1) CONC_PRECISION=AUTO
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X CONC_PRECISION=AUTO
AUTO 1 2 3 4 ENTR EXIT
SETUP X.X 5) STABIL_GAS=CO
PREV NEXT JUMP EDIT PRNT EXIT
SETUP X.X STABIL_GAS=O2
CO CO2 O2 ENTR EXIT
Use these buttons to select
which gas will be reported
by the sTABIL test
function.
(O
2
is only available if the
optional O
2
sensor is
installed)
Use these buttons to select
the precision of the o33
concentration display.
Press NEXT for additional
VARS; press NEXT or
PREV to move back and
forth throughout the list of
VARS.
5.9. SETUP DIAG: DIAGNOSTICS FUNCTIONS
A series of diagnostic tools is grouped together under the SETUPMOREDIAG
menu, as these parameters are dependent on firmware revision (see Appendix A). These
tools can be used in a variety of troubleshooting and diagnostic procedures and are