Teledyne analytical instruments 161 – Teledyne GFC-7001T - Trace CO Analyzer User Manual
Page 161
CommunicationsTeledyne API – Model T300/T300M CO Analyzer
Teledyne
Analytical
Instruments
161
To assign or reset the status flag bit assignments, press:
SAMPLE
RANGE=50.0 PPM CO= XX.XX
<TST
TST> CAL
SETUP
DEL deletes the
character currently
inside the cursor
brackets.
Press the [?] button repeatedly to cycle
through the available character set: 0-9
NOTE: Values of A-F can also be set
but are meaningless.
The <CH and CH>
buttons move the
cursor brackets “[ ]”
left and right along the
bit string.
SETUP X.X
HESSEN STATUS FLAGS
<SET
EDIT
EXIT
SETUP X.X
COMMUNICATIONS MENU
ID
HESN
COM1 COM2
EXIT
SETUP X.X
HESSEN VARIATION:TYPE1
<SET
SET>
EDIT
EXIT
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
MORE
EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM
VARS DIAG
EXIT
Continue pressing NEXT until ...
SETUP X.X
SOURCE WARNING:0004
NEXT
EDIT PRNT EXIT
SETUP X.X
BOX TEMP WARNING:[0]008
<CH CH>
DEL
[0]
ENTR EXIT
SETUP X.X
SAMPLE TEMP WARNING:0020
PREV NEXT
EDIT
PRNT EXIT
Continue pressing NEXT until desired
flag message is displayed
EXIT discards the
new setting.
ENTR accepts the
new setting.
6.7.3.5. INSTRUMENT ID
Each instrument on a Hessen Protocol network must have a unique identifier (ID
number). If more than one GFC7001T/GFC7001TM analyzer is on the Hessen network,
refer to Section 5.7.1 for information and to customize the ID of each.