Teledyne GFC-7001T - Trace CO Analyzer - Manual (Page 81)

Getting StartedTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 81
3.4.4.3. O
2
SENSOR CALIBRATION PROCEDURE
If your GFC7001T/GFC7001TM is equipped with the optional O
2
sensor, this sensor
should be calibrated during installation of the instrument. See Section 9.7.1 for
instructions. Refer to any addenda that may accompany this instrument for custom
configuration such as an optional O
2
sensor.
3.4.4.4. CO
2
SENSOR CALIBRATION PROCEDURE
If your GFC7001T/GFC7001TM is equipped with the optional CO
2
sensor, this sensor
should be calibrated during installation of the instrument. See Section 9.7.2 for
instructions. Refer to any addenda that may accompany this instrument for custom
configuration such as an optional CO
2
sensor.
Note Once you have completed the above set-up procedures, please fill out
the Quality Questionnaire that was shipped with your unit and return it
to TAI. This information is vital to our efforts in continuously improving
our service and our products. THANK YOU.