Signal i/o – Teledyne GFC-7001T - Trace CO Analyzer User Manual
Page 115
Advertising
SetupTeledyne API – Model T300/T300M CO Analyzer
Teledyne
Analytical
Instruments
115
5.9.1. SIGNAL I/O
The signal I/O diagnostic mode allows a user to review and change the digital and
analog input/output functions of the analyzer. Refer to Appendix A-4 for a full list of
the parameters available for review under this menu.
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
Any changes of signal I/O settings will remain in effect only until the
signal I/O menu is exited. Exceptions are the ozone generator override
and the flow sensor calibration, which remain as entered when exiting.
Access the SIGNAL I/O test mode from the DIAG Menu:
Advertising