Teledyne GFC-7001T - Trace CO Analyzer - Manual (Page 4)

Model GFC7001T Carbon Monoxide Analyzer
Teledyne Analytical Instruments iv
Selected Options for the Model GFC 7001T
M OUNTING O PTIONS
19” rack mounting with 26” sliders with ears
19” rack mounting with ears only
R EAR P ANEL G AS F ITTINGS
1/4” SS Standard
6 mm SS Optional
V ALVE O PTIONS
No Valves. The standard unit does not include internal span and zero valves.
Internal Zero/Span Valves
A LARM R ELAYS
The standard instrument is equipped with two configurable concentration alarms and one fixed system
failure alarm. This is an optional feature for GFC 7001TU version. The alarm relays for this instrument
are configured as:
Hi, Hi-Hi, and System
APCI Configuration:
AL1 energized when there is no fault detected and de-energized in a fault condition.
AL2 configured as High Range Status and is energized when in high range.
AL3 configured as Zero Calibration Status and is energized in zero calibration mode.
T EST O PTIONS
The following optional tests with data reports must be requested at the time of order:
10 Point Linearity Test: For enhanced accuracy, a 10-point linearity test is performed at the
factory during the setup and testing phase for this analyzer. Data results are included.
Temperature Compensation Test: Thermal testing is performed at the factory to accurately
determine the temperature coefficient to be used in specific applications. Data results are
included.
P ROFIBUS M OUNTING O PTION
RS232 to Profibus Circuit Board: Special RS232 to Profibus PCB card for Profibus
communication using the existing RS232 port.
B ACKGROUND G AS :
N OTES :