Disable interface linktrap – Allied Telesis AT-S63 User Manual
Page 113
AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations
113
DISABLE INTERFACE LINKTRAP
Syntax
disable interface=
port
linktrap
Parameter
port
Specifies the port on which you want to disable SNMP
link traps. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22).
Description
This command disables SNMP link traps on a port. When disabled, the
switch does not send an SNMP link trap when there is a change to the
status of a link on a port.
Note
In order for the switch to send SNMP traps to SNMP trap receivers,
you must activate SNMP on the unit and specify one or more trap
receivers.
Example
The following command disables link traps on port 21:
disable interface=21 linktrap