Enable ip route multipath – Allied Telesis AT-S63 User Manual
Page 586
Chapter 32: Internet Protocol Version 4 Packet Routing
586
Section VII: Internet Protocol Routing
ENABLE IP ROUTE MULTIPATH
Syntax
enable ip route multipath
Parameters
None.
Description
This command enables the ECMP feature. When this feature is enabled,
the routing table in the switch routes packets to a specific remote
destination using more than one route when the table contains multiple
static or dynamic routes to the destination. The table can contain up to 32
routes to the same destination and up to eight of the routes can be active
at one time. The default setting for ECMP is enabled. For background
information on this feature, refer to “Equal-cost Multi-path (ECMP)
Routing” on page 556. To view the current status of ECMP on the switch,
use the SHOW IP ROUTE command with the GENERAL parameter. For
instructions, refer to “SHOW IP ROUTE” on page 607.
Example
The following example enables ECMP on the switch:
enable ip route multipath