Allied Telesis AT-S63 - Manual (Page 152)

Chapter 9: MAC Address Table Commands
152 Section I: Basic Operations
SHOW SWITCH AGINGTIMER|AGEINGTIMER
Syntax
show switch agingtimer|ageingtimer
Parameters
None.
Description
This command displays the current setting for the aging timer. The switch
uses the aging timer to delete inactive dynamic MAC addresses from the
MAC address table. To set the aging timer, refer to “SET SWITCH
AGINGTIMER|AGEINGTIMER” on page 151.
Figure 9 illustrates the information displayed by this command.
Figure 9. SHOW SWITCH AGINGTIMER|AGEINGTIMER Command
Example
The following command displays the current setting for the MAC address
aging timer:
show switch agingtimer
Aging interval: 300 second(s)